Muratec OFFICEBRIDGE IF-100 AND IF-200 Operations Instructions download pdf (Page 11)

IF-200 from Muratec

3.2. Initial Setup

Step 1: Refer to the IF-200 Worksheet in Appendix A of this guide for the required

information. Complete the Worksheet under "Settings for your ISP/Mailbox.” Your

network system administrator can provide the data required to complete the worksheet.

Step 2: After you have completed the IF-200 Worksheet, turn on the IF-200 using the

power switch on the rear panel. The LCD screen shows messages. Follow the instructions

on the LCD screen and use the keys on the front panel to enter information. After the IF-

200 has been set up, the information remains in memory, even if the power is turned off.

After the power is turned on, the Welcome screen appears after a few seconds.

Press any key to start the setup process.

Make sure your fax machine is connected

to the IF-200. Press any key to continue the

setup process.

If you have not already completed the

Worksheet in the appendix of this guide,

press YES to print out a Worksheet.

If the Worksheet is completed, press NO

and go to section 3.3, “Entering your ISP

and Mailbox Information”.

If you pressed YES above, you see the

screen shown to the left. Press YES if the

Worksheet printed.* Press NO to try again.

*Using this blank Worksheet or the sample Worksheet in the back of this guide, ask your

local LAN or IT administrator to provide the information requested. It will be required in

the next section of this Guide to attach the IF-200 to the LAN.

WELCOME to the world

of IP Fax Mail!

vX.XX

Connect FAX machine

to FAX port on the

IF-200

Print IF-200

worksheet detailing

required ISP info?

YES NO

Did worksheet

print OK?

ES NO

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 40 41

No comments

Muratec OFFICEBRIDGE IF-100 AND IF-200 Operations Instructions Page 11