Scanning the document
The scanned document will be stored in the Personal Inbox of the specific UserID you entered.
To scan the document:
1
Press COPY / FAX / SCAN repeatedly until the following dis-
play is shown:
In Scanner mode, the COPY light and FAX light will be
turned off.
2
Set the document in the ADF (Automatic Document Feeder)
or on the FBS (FlatBed Scanner) glass.
3
To improve the scanning quality, you can temporarily change the following settings.
• Document type — Press DOCUMENT / RESOLUTION to select the document type from Text,
Photo/Text or Photo you want.
• Contrast — Press CONTRAST to select the contrast you want.
• Reduction/Enlargement — You can select the preset ratio by pressing or , or press SPEED DIAL/
TEL INDEX twice (ZOOM right will glow) and adjust the ratio by 1 percent increments using or ,
or directly enter any percentage between 50 % and 200 % by following procedure.
1. Press #.
2. Using the numeric key to enter your desired ratio (50 to 200).
3. Press # again.
Note: The enlargement is available only for scanning using the FBS. It is not available for scanning
through the ADF.
Note: The Scanning resolution does not change in this time. If you are using the MFX-1700 and you want
to change the scanning resolution, see “Setting scan parameter” on page 40.
4
Enter the User ID by using by any combination of the following methods:
• Using One-touch key
• Using Speed dial number
• Directly entering
Note: To use One-touch key and Speed dial number, the User ID should be registered with them in
advance. You can register them on the “Administration Tools” screen, page 22.
Note: To enter many User IDs of recipient, press BROADCAST first.
Using One-touch key:
1. Press One-touch key where the User ID you want to send is
registered.
2. Go to step 10.
Note: If the “Scan Mode Prompt setting” has been set to On (see page 43),
go to step 5.
Set UserID 100%
[01]_
Set UserID 100%
_
44
Comments to this Manuals