Muratec F-565 Specifications download pdf (Page 282)

4-16

4.10.3 Transmission errors

T.1.1 T1 time-out. The remote fax machine didn’t respond to your machine. This usually occurs

during a manual transmission or when an incorrect number was dialed. Call someone at the

remote machine.

T.1.4 Someone pressed <Stop> during fax transmission.

T.2.1 CFR or FTT was not received from the remote machine. Either the phone line disconnected

during fax communication or transmission became impossible due to bad phone line

conditions. Try the call again. It may be necessary to increase the output levels on Machine

Parameter 001. The receive machine may also have closed network or block junk fax

enabled.

T.2.2 The two fax machines were incompatible. No mailbox at receiver or security transmission is

enabled.

T.2.3 FTT was received from the remote machine at 2400 bps. Bad phone line conditions made

fax communication impossible. Conditions can change rapidly, so try the call later. Turn on

the echo protect tone on Memory Switch 010. Also adjust the interval between DCS and TCF

on Memory Switch 011. If the problem persists, try increasing the output levels on Machine

Parameter 001.

T.3.1 The page counter in the fax machine detected a document feeder error during transmission.

Carefully re-insert the document into the feeder and re-try the call.

T.4.1

No response to MPS/EOP/EOM. Poor phone lines caused the receiving unit to disconnect.

Adjust the interval between CFR and data on Memory Switch 011. Try increasing the output

levels on Machine Parameter 001. It may also be necessary to adjust the transmit speed on

Memory Switch 010.

T.4.2 RTN was received from the remote machine. After transmission began, poor line conditions

developed. Try the call again. Attempt the solutions described for the T.4.1 error.

T.4.4 Poor line conditions prevented transmission. PIP was received. The transmission was

interrupted by the call mode. The receiving unit may be experiencing problems. Try the call

again.

T.5.1 No response to RR from the remote machine. Line noise or other problems prevented ECM

transmission. Increase the ECM response time on Memory Switch 012.

T.5.2 No response to CTC. Line noise or other problems prevented ECM transmission. Increase the

ECM response time on Memory Switch 012.

T.5.3 EOR was received from the remote unit but further transmission was not possible. Adjust

Memory Switch 015 for this problem.

T.8.1 A compatibility error occurred.

T.8.10 Line noise or other problems prevented line probing.

T.8.11 The remote fax machine didn’t complete the equalizer training phase.

1 2 ... 277 278 279 280 281 282 283 284 285 286 287 ... 382 383

No comments

Muratec F-565 Specifications Page 282