Muratec MFX-3550 User's Guide download pdf (Page 47)

Setting IP address

Firstly, you have to set up an IP address for network printing and managements. In most cases a

new IP address will be automatically assigned by a DHCP (Dynamic Host Configuration Protocol

Server) located on the network.

In a few situations the IP address must be set manually. This is called a static IP and is often

required in corporate intranets for security reasons.

DHCP IP assignment: Connect your machine to the network, and wait a few minutes for the

DHCP server to assign an IP address to the machine. Then, print the Network Configuration

Report as explained above. If the report shows that the IP address has changed, the assignment

was successful. You will see the new IP address in the report.

Static IP assignment: Use SetIP program to change the IP address from your computer. If

your machine has a control panel, you can also change IP address using the machine's control

panel.

In an office environment, we recommend that you contact a network administrator to set this

address for you.

IP setting using control panel

1. Connect your machine to the network with an RJ-45 Ethernet cable.

2. Turned on the machine.

3. Press Menu on the control panel.

4. Press the up/down arrow to highlight Network and press OK.

5. Press the up/down arrow to highlight TCP/IP and press OK.

6. Press the up/down arrow to highlight Static and press OK.

7. Press the up/down arrow to highlight IP Address and press OK.

8. Enter the IP address using numeric keypad and press OK.

9. Enter other parameters, such as the Subnet Mask and Gateway and press OK.

10. After entering all parameters, press Stop/Clear to return to ready mode.

Now go to "Installing wireless network connected machine’s driver" on page 9.

IP setting using SetIP Program (Windows)

This program is for manually setting the network IP address of your machine using its MAC

address to communicate with the machine. A MAC address is the hardware serial number of the

network interface and can be found in the Network Configuration Report.

For using SetIP program, disable the computer firewall before continuing by performing the

following:

1. Open Control Panel.

2. Double click Security Center.

3. Click Windows Firewall.

4. Disable the firewall.

Installing the program

1. Insert the Printer Software CD-ROM provided with your machine. When the driver CD runs

automatically, close that window.

2. Start a web browser such as Internet Explorer and open the X drive. (X represents your CD-

You only need to run this program if your network requires a static IP address. Otherwise,

you may proceed to the configuring the machine’s wireless network of this document. If

you are unsure of this requirement ask the system administrator or the person who has

set up your local network. (See Configuring the machine’s wireless network.)

You can only use the SetIP program when your machine is connected to a network or

directly connected to a computer with the crossover network cable included with your

machine. In most cases we recommend using the crossover cable.

e 11 of 24

etwork setu

8/4/2009htt

://downloadcenter.samsun

.com/content/UM/200907/20090721152022250/EN/en

lish

...

1 2 ... 42 43 44 45 46 47 48 49 50 51 52 ... 212 213

Muratec MFX-3550 User's Guide Page 47

Comments to this Manuals

Muratec MFX-3550 User's Guide Page 47

Comments to this Manuals

Related products and manuals for Laser/LED printers Muratec MFX-3550