Muratec MFX-3550 User's Guide Page 79

  • Download
  • Add to my manuals
  • Print
  • Page
    / 213
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 78
{
Condition: Do not use labels with wrinkles, bubbles, or other indications of separation.
z
Make sure that there is no exposed adhesive material between labels. Exposed areas can cause
labels to peel off during printing, which can cause paper jams. Exposed adhesive can also cause
damage to machine components.
z
Do not run a sheet of labels through the machine more than once. The adhesive backing is
designed for only a single pass through the machine.
z
Do not use labels that are separating from the backing sheet or are wrinkled, bubbled, or
otherwise damaged.
Card stock/ Custom-sized paper
z
Do not print on media smaller than 76.2 mm (3 inches) wide or 127 mm (5 inches) long.
z
In the software application, set margins at least 6.4 mm (0.25 inches) away from the edges of
the material.
Preprinted paper
When loading preprinted paper, printed side should be facing down with an uncurled edge at the
front. If you experience problems with paper feed, turn the paper around. Note that print quality is
not guaranteed.
z
Preprinted paper must be printed with heat-resistant ink that will not melt, vaporize, or release
hazardous emissions when subjected to the machine’s fusing temperature for 0.1 second. Check
your machine’s specification to view the fusing temperature. (See General specifications
.)
z
Preprinted paper ink must be non-flammable and should not adversely affect machine rollers.
z
Forms should be sealed in a moisture-proof wrapping to prevent changes during storage.
z
Before you load preprinted paper, verify that the ink on the paper is dry. During the fusing
Pa
g
e 12 of 14Media and tra
y
8/4/2009htt
p
://downloadcenter.samsun
g
.com/content/UM/200907/20090721152022250/EN/en
g
lish
/
...
78
Page view 78
1 2 ... 74 75 76 77 78 79 80 81 82 83 84 ... 212 213

Comments to this Manuals

No comments