Muratec MFX-1330 Specifications download pdf (Page 182)

4-20

4.14 Error Codes

If an error occurs during a communication, a check message will be printed. The following provides an

explanation of the information found on check messages.

A possible solution to the problem

The date and time of the attempted communication

The sending location (if the remote fax has a Location ID)

The number of pages which got through before the error terminated the call

The error code

The sample document.

You will also see a code listed in the Result column of the report. Result codes indicate the specific

problem encountered:

“D” codes occur while dialing

“R” codes occur during reception

“T” codes occur during transmission

Here is a list of error codes the fax machine may print.

Dialing errors

D.0.2 The remote unit is busy. Try the call again.

D.0.3, The remote unit didn’t respond, the call couldn’t be completed or stop was pressed during

D.0.8 dialing. Retry the call. If your machine repeats the message, call the remote fax unit’s

operator and verify that unit is operating properly.

D.0.6, Either the remote unit didn’t respond, the call somehow didn’t go through or STOP was

D.0.7 pressed during dialing. Try the call again.

Reception errors

R.1.1 T1 time-out. The calling unit was not a fax machine or the transmitting unit is having

difficulties.

R.1.2 The two fax machines were incompatible. Your machine sends and receives only ITU-T

Group 3 fax communication, the industry standard since the early 1980s.

R.1.4 Someone pressed STOP during fax reception.

R.2.3 Poor phone line conditions made fax communication impossible. Enable the one second

pause after CED on Memory Switch 20. Also try increasing the echo wait time on Memory

Switch 21 if echo is on the line.

R.3.1 No response to CFR. DCN was received from the transmitter. Poor line conditions made

communication impossible. Adjust the echo wait time on Memory Switch 21. Try increasing

the output levels via Machine Parameter A:1.

R.3.3 Too many errors were detected during data reception. The carrier was interrupted. Increase

the data error rate on Memory Switch C:0.

R.3.4 DCN was received after FTT. Communication was not possible at 2400 bps. Poor phone line

conditions prevented fax communication. Enable the Eye Quality Check on Memory Switch

31 and 32.

R.4.1 The machine received too large length data that over your machine’s limit.

R.4.2 MPS/EOM/EOP was not received. Either the line disconnected before reception was

completed or too many errors were detected by the receiving unit. Adjust the data error rate

on Memory Switch C:0. It may also be necessary to decrease the receive communication

speed via Memory Switch C:0.

1 2 ... 177 178 179 180 181 182 183 184 185 186 187 ... 289 290

Comments to this Manuals

No comments

Muratec MFX-1330 Specifications Page 182

Comments to this Manuals

Related products and manuals for Multifunctionals Muratec MFX-1330