© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
3
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
Brother – TN330 / TN360
REQUIRED FOR A SUCCESSFUL REFILL:
Toner
1 funnel
General Relling Procedures:
Use a Flathead screwdriver to pop out the large plastic plug found on the side of the
side of the cartridge.
IMPORTANT: You must dispose of any original toner in the cartridge as much as
possible before relling. Dispose of toner properly into a trash can, or use a vacuum
with a hose for best results (if possible).
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen
the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle.
Attach the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the ll-
ing hole and insert it into the hole. If the toner stops owing before the cartridge is full,
simply remove the toner, close the cap, turn the bottle upside down and tap it on a table.
Once the cartridge is full, seal the hole with the plug by twisting it until it is completely
seated. Now gently shake the cartridge side to side to distribute the toner.
Installing Reset Gear on Starter Cartridges
1. Remove the screws circled in red in the illustration
above. Carefully detach the panel from the cartridge.
2. Reset the ag gear by turning it into the correct
position. The picture on the right shows the ag gear
in the correct position.
3. Screw the panel back into place, and your cartridge is ready.
Rell Hole
The ag gear here is in
the correct position
Remove screws to
detach panel for resetting
Comments to this Manuals