Muratec M-1900 User Manual download pdf (Page 137)

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

130

Please be advised that some toner rell kits may be

compatible with multiple toner cartridges.

CLICK HERE TO GO THE INDEX

Xerox Phaser 7300

REQUIRED FOR A SUCCESSFUL REFILL:

 Toner

 1 funnel cap

Note: Please read carefully before relling cartridge.

General Relling Procedures:

Hopper section is separated into two sections; one side of the hopper is for the

toner delivery and contains the toner ready for printing. The other side is for the

Waste toner, toner is spread evenly across this section by means of an Archime-

des screw. It is essential that all the toner is removed from both of these two

sections, before the new toner is placed into the hopper unit. Simply opening

the gate at the bottom of the hopper, and pulling out the black bung on the side,

gives us the opportunity to thoroughly clean the new toner section of the hopper.

To clean the waste section: On the side of the hopper is a spring loaded gate,

which can be pushed back to open the waste section to allow cleaning. Pour all

waste toner out and discard it. When you have emptied the waste toner, remember

to place the plug back into its place.

Now the cartridge can be relled. Using illustration D as a reference carefully

remove the hopper plug by placing a small at blade screwdriver behind the lip

of the bung, and prise it away from the hopper unit. Care should be taken when

relling the hopper unit, as toner can leak out of the main gate, simply place some

tape over the gate area whilst lling to stop leaking.

Before opening the bottle of toner, turn it upside down and tap it on a table to loosen

the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle.

Attach the funnel cap making to sure it is on tightly. Tilt the cartridge at a 45 degree

angle and then the funnel cap toward the lling hole and insert it into the hole. If the

toner stops owing before the cartridge is full, simply remove the toner, close the

cap, turn the bottle upside down and tap it on a table. Once you are done relling this

cartridge, replace the plug back into its place and combine the toner unit with the

drum unit. Your cartridge is now ready for use.

A. Toner unit (top) Drum unit (bottom)

B. Toner unit

C. Waste hopper section D. Toner hopper section

1 2 ... 132 133 134 135 136 137 138 139 140 141 142

Comments to this Manuals

No comments

Muratec M-1900 User Manual Page 137

Comments to this Manuals

Related products and manuals for Fax machines Muratec M-1900