Muratec M-1900 User Manual Page 110

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 109
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
103
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
Ricoh CL4000 / SP C410 / C411
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 funnel cap
 cutting pliers
 Glue
Note: Please read carefully before relling cartridge.
General Relling Procedures:
Make sure you hold this cartridge in an upright position when opening the rell hole
(some remaining or excess toner can and may fall out of the cartridge). Slide the
small cover door, shown in picture B, to the left gently. Please be careful not to slide
this small door off the track (it can be quite difcult to replace).
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen
the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle.
Attach the funnel cap making to sure it is on tightly. Tilt the cartridge at a 45 degree
angle and then the funnel cap toward the lling hole and insert it into the hole. If the
toner stops owing before the cartridge is full, simply remove the toner, close the
cap, turn the bottle upside down and tap it on a table. If the funnel cap you are pro-
vided is much larger than the opening of the rell hole, you can use plain paper or
news paper as an alternative assistant to help guide the toner directly into the hole.
When you are done relling this cartridge, slide the small door back to its original
position, so that the hole is no longer exposed.
You can now place your cartridge back into your printer as shown in picture A.
NOTE: If picture A looks different than your printer, please set colors according
to your printer.
A.
B. C.
Gently slide cover
open
How to replace the chip
NESTED OEM
NESTED COMPATIBLE
Replaced with
glue
Cut Notch
IMPORTANT: DO NOT GET GLUE NEAR OR
ON THE CONTACTS
With some pliers, clip off the tab closest to the edge of the cartridge.
Remove the OEM chip from the cartridge and ensure the tab surface is smooth and
level. Slide the replacement chip into place (The chip should slide comfortably under
the notch that was not removed). With a hot glue gun, or crazy glue, hold the chip
and glue the end of it as shown in the illustration above (Nested Compatible). Do not
get any glue near or on the contacts of the chip as it can cause damage to the chip.
Very small amounts of glue will do, and will also be make removing the chip easy on
your next rell.
Page view 109
1 2 ... 105 106 107 108 109 110 111 112 113 114 115 ... 141 142

Comments to this Manuals

No comments