Muratec M-1900 User Manual Page 135

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 134
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
128
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
Xerox – 106R482
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 funnel cap
General Relling Procedures:
Use a screwdriver to remove the small screw holding the waste hopper in place. Turn
the cartridge over, press on the clear plastic tab while pressing on the tab gently turn
the waste hopper away from the body of the cartridge. Do not be alarmed if the plastic
prong cracks or breaks off. Use a screwdriver to remove the two small screws to release
the end cap. Lift up on the end cap while pulling it to the left to remove it. You will
now see a large plastic plug. Use a athead screwdriver to pop out the large plastic plug
found on the side of the side of the cartridge.
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen
the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle.
Attach the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the
lling hole and insert it into the hole. If the toner stops owing before the cartridge is
full, simply remove the toner, close the cap, turn the bottle upside down and tap it on
a table. Once the cartridge is full, seal the hole with the plug by twisting it until it is
completely seated.
Perform the following steps over a newspaper:
Slide open the door over the waste hopper and dump out the waste toner onto the
newspaper. Reassemble the cartridge. Now gently shake the cartridge side to side to
distribute the toner.
DEVELOPER NOTE:
Adding developer onto your cartridge’s magnetic roller is similar to pouring mustard
on a hotdog. Applying less developer is better than applying too much developer.
Pour a thin bead of developer across the length of the magnetic roller.
Rotate the roller counter-clockwise (to spread the developer across the magnetic roller
) then print a sample.
If the printer takes a while to “warm up,” then try adding a little more developer. This
time, rotating the magnetic roller clockwise. Note: When nished, the magnetic roller
will be “bald” in some areas. This is normal.
Page view 134

Comments to this Manuals

No comments