
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
115
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
Samsung ML-7000
REQUIRED FOR A SUCCESSFUL REFILL:
Toner
1 funnel cap
1 Flathead screwdriver
1 Phillips screwdriver
Note: Please read carefully before relling cartridge.
General Relling Procedures:
1. Clean the exterior of the cartridge.
2. Place the cartridge with the toner hopper away from you. Remove the
Drum cover by unsnapping the bar from both the right and left sides of
the cartridge. Note the cover spring orientation for when it is re-installed.
See Figure’s A & B. (The spring has been colorized to better show its
position).
3. Un-hook the small springs from both sides of the toner hopper. See
Figure C.
4. On the right side, remove the two screws from the end cap. Re move the
end cap. See Figure D.
5. Remove the entire waste section by working the left end cap free from
the hopper. It is just held on by pressure. See Figure E.
6. Remove the two screws and plastic bushing from the right side end cap.
See Figure F.
Instructions Continue on next page...
Figure A.
Figure C.
Figure E.
Figure F.
Figure D.
Figure B
Page 1 of 2
Comments to this Manuals