Muratec M-1900 User Manual Page 94

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 93
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
87
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
LEXMARK C522 / C524 / C530 / C532 / C534
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 funnel cap
General Relling Procedures:
Using a T-10 Torx screwdriver remove the two screws either side of the doctor blade.
Using a Philips screwdriver remove the two screws and washers from the centre of
the doctor blade (picture 1). Remove the top metal strip from the cartridge. Lift out
the doctor blade (picture 2 & 3). Remove the two screws holding the blue cartridge
handle in place on the non-geared side of the cartridge (picture 4 & 5).
Note: the bottom screw is longer than the top screw. The metal contact strip and blue
handle can be removed from the hopper unit.
To remove the developer roller – this can be twisted and pulled out from the white
gear side of the cartridge.
Optional: Use Isopropanol Alcohol to clean the developer roller, although there are a
number of roller cleaning agents available (picture 9).
IMPORTANT: You must dispose of any original toner in the cartridge as much as
possible before relling. Dispose of toner properly into a trash can, or use a vacuum
with a hose for best results (if possible).
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen
the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle. At-
tach the funnel cap making to sure it is on tightly. Rell the cartridge directly through
the developer roller area (picture 10). If the toner stops owing before the cartridge is
full, simply remove the toner, close the cap, turn the bottle upside down and tap it on
a table. Once the cartridge is full, seal the hole with the plug by twisting it until it is
completely seated.
Reassemble the cartridge. Now gently shake the cartridge side to side to distribute the
toner.
1. 2.
3.
4.
5.
6.
7.
9.
10.
For Chip replacement please see next page...
Page view 93
1 2 ... 89 90 91 92 93 94 95 96 97 98 99 ... 141 142

Comments to this Manuals

No comments