Muratec M-1900 User Manual Page 96

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 95
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
89
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
LEXMARK T420
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 funnel cap
 1 replacement chip
General Relling Procedures:
1. First you need to locate the plastic SEALING PLUG similar to the one shown in
this diagram. To access the plug, you may need to remove some springs which hold the
END CAP over this plug. Please look at diagrams A-E, In steps A and B you remove the
springs on the cartridge (Make sure these do not break, bend, or get lost as you will need
them again). In step C, start to remove the side panel by gently lifting it from the cartridge ,
and then pulling away from the cartridge You will need to complete step D to fully remove
the casing off the cartridge that will give you full access to the toner rell hole (diagram E).
2. Once the plastic sealing plug is viewable, slowly and gently, pry the SEALING
PLUG away from the cartridge using a at head screwdriver – this reveals the lling hole.
3. Rell by pouring toner into the ll hole through the nozzle attached to the toner
bottle.
4. Replace the plug when nished relling
5. This cartridge has a MEMORY CHIP which needs to be replaced in order for the
printer to sense that there is toner in the cartridge. Simply remove the old chip by
B.A.
C.
Page view 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 141 142

Comments to this Manuals

No comments