Muratec M-1900 User Manual download pdf (Page 82)

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

Please be advised that some toner rell kits may be

compatible with multiple toner cartridges.

CLICK HERE TO GO THE INDEX

REQUIRED FOR A SUCCESSFUL REFILL:

 Toner

 1 funnel cap

 1 hole plug (Optional)

 Electrical Tape/Duct Tape

 Toner Hole Making Tool

General Relling Procedures:

Rest the Hole Making Tool on its stand and plug into an outlet. Wait 3 full minutes before using. Position the copper bit on the cartridge in the spot indicated in photograph A and

push gently until it melts a hole in the cartridge. Be careful not to put to much pressure into the cartridge when creating the hole. Doing so can cause damage to the inside parts of the

cartridge if the tool slips and touches any parts inside. Make sure to keep the hole on the at surface of the cartridge and not on the curved edge. Remove the tool, place it back on its

stand and unplug it. If the small piece of plastic has fallen into the cartridge, it must be removed, as this can damage your cartridge or cause print defects. If the piece remains in the

tool, wait for the tool to cool down and pry it out.

IMPORTANT: You must dispose of any original toner in the cartridge as much as possible before relling. Dispose of toner properly into a trash can . Do not overll the car-

tridge by pouring the entire toner powder into the cartridge. Use half the bottle now, and the rest at a later time. Overlling can and will damage a cartridge.

Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle. Attach the

funnel cap making to sure it is on tightly. Tilt the funnel cap toward the lling hole and insert it into the hole. If the toner stops owing before the cartridge is full, simply remove the

toner, close the cap, turn the bottle upside down and tap it on a table. Once the cartridge is full seal the hole with the plug or tape.

Once the cartridge is sealed, rock it back and forth to distribute the toner. Remember to replace the chip before inserting the cartridge back into your printer. Once that has been

Replace chip. You may

need to modify the chip

holding area.

Create rell

hole here.

HP CP2025 / CP2020

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 141 142

Comments to this Manuals

No comments

Muratec M-1900 User Manual Page 82

Comments to this Manuals

Related products and manuals for Fax machines Muratec M-1900