Muratec M-1900 User Manual download pdf (Page 48)

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

Please be advised that some toner rell kits may be

compatible with multiple toner cartridges.

CLICK HERE TO GO THE INDEX

REQUIRED FOR A SUCCESSFUL REFILL:

 Toner

 1 funnel cap

 1 hole plug

 Toner Hole Making Tool

General Relling Procedures:

Rest the Hole Making Tool on its stand and plug into an outlet. Wait 3 full minutes

before using.

Turn the cartridge so that the handle is facing up. Position the copper bit on the car-

tridge in the spot indicated by the photograph and push gently until it melts a hole in the

cartridge. Remove the tool, place it back on its stand and unplug it. If the small piece

of plastic has fallen into the cartridge, it must be removed, as this can damage your

cartridge or cause print defects. If the piece remains in the tool, wait for the tool to cool

down and pry it out.

Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the

toner and allow it to ow freely. Remove the cap and pull the seal off the bottle. Attach

the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the lling hole

and insert it into the hole. If the toner stops owing before the cartridge is full, simply

remove the toner, close the cap, turn the bottle upside down and tap it on a table. Once

the cartridge is full seal the hole with the plug.

Do not press down on the plug since the cartridge is resting on a table this can actually

damage the photo-optic drum. Instead hold one end of the cartridge up off the table

and twist the plug until it fully sealed. Now gently shake the cartridge side to side to

distribute the toner.

NOTE: If after the cartridge is relled and it starts to print gray smudges or smears

along the margin, the waste hopper could be full. Please refer to the supplemental in-

structions (page 2) for emptying the waste hopper.

HP Q2612A/X

Rell Hole

Waste Hopper

Waste Hopper Instructions for HP Q2612A:

(Do this procedure over a newspaper)

Turn the cartridge the way it would be inserted into the printer. Using the hole making

tool, position the copper bit on the cartridge in the spot indicated by the photograph and

push gently until it melts a hole in the cartridge. Once the hole has been made, turn the

cartridge over so that the hole is facing the newspaper. Gently rock the cartridge back and

forth allowing the toner to fall onto the newspaper. Do this repeatedly to remove as much

waste toner as possible. Don’t worry about getting all of the toner out. Now clean around

hole with a soft dry cloth. Use duct tape to seal the hole.

1 2 ... 43 44 45 46 47 48 49 50 51 52 53 ... 141 142

Comments to this Manuals

No comments

Muratec M-1900 User Manual Page 48

Comments to this Manuals

Related products and manuals for Fax machines Muratec M-1900