Muratec M-1900 User Manual Page 52

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 51
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
45
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
A.
B.
C.
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 Phillips screwdriver and at head screw driver
 Needle nose pliers
Note: Please read carefully before relling cartridge.
General Relling Procedures:
Using the screw driver, remove the screws on the side of the cartridge so that
the sealing plug can be revealed (Picture A.). Once you have located the sealing
plug, use the at head screw driver to gently loosen the sealing plug(Picture B.).
With the needle nose pliers, gently, but forcefully pull the plug completely off
the cartridge. If the plug happens to bent or crack, you may use electrical tape
or duct tape to securely seal the cracks or bents once you have replaced the plug
at the end of the rell process.
Empty any toner left inside the cartridge (mixing two different brands of
toners could result in bad printing, and unpredictable results).
Before opening the bottle of toner, turn it upside down and tap it on a table to
loosen the toner and allow it to ow freely. Remove the cap and pull the seal off
the bottle. Attach the funnel cap making to sure it is on tightly. Tilt the cartridge
at a 45 degree angle and then the funnel cap toward the lling hole and insert
it into the hole. If the toner stops owing before the cartridge is full, simply
remove the toner, close the cap, turn the bottle upside down and tap it on a
table. Once you are done relling this cartridge, place the sealing plug back in
its place and use duct tape or electrical tape to seal up any necessary cracks on
the plug.
Replace the Smart Chip on the cartridge before placing it back into the printer.
The chip may need to be pryed from its location gently. Once the chip has been
replaced, insert the cartridge into the printer and run a few test pages.
HP CC364
Page view 51
1 2 ... 47 48 49 50 51 52 53 54 55 56 57 ... 141 142

Comments to this Manuals

No comments