Muratec M-1900 User Manual Page 55

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 54
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
48
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
HP – Q1338A / Q1339A
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 funnel cap
 1 hole plug (electrical or duct tape will do as well)
 Toner Hole Making Tool
General Relling Procedures:
Rest the Hole Making Tool on its stand and plug into an outlet. Wait 3 full minutes before using.
Position the copper bit on the cartridge in the spot indicated in photograph A and push gently until
it melts a hole in the cartridge. Make sure to keep the hole on the at surface of the cartridge and not
on the curved edge. Remove the tool, place it back on its stand and unplug it. If the small piece of
plastic has fallen into the cartridge, it must be removed, as this can damage your cartridge or cause
print defects. If the piece remains in the tool, wait for the tool to cool down and pry it out.
IMPORTANT: You must dispose of any original toner in the cartridge as much as possible before
relling. Dispose of toner properly into a trash can, or use a vacuum with a hose for best results
(if possible).
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the toner and
allow it to ow freely. Remove the cap and pull the seal off the bottle. Attach the funnel cap mak-
ing to sure it is on tightly. Tilt the funnel cap toward the lling hole and insert it into the hole. If the
toner stops owing before the cartridge is full, simply remove the toner, close the cap, turn the bottle
upside down and tap it on a table. Once the cartridge is full seal the hole with the plug.
Do not press down on the plug since the cartridge is resting on a table this can actually damage the
photo-optic drum. Instead hold one end of the cartridge up off the table and twist the plug until it
fully sealed. Now gently shake the cartridge side to side to distribute the toner.
Create Rell hole here
Page view 54
1 2 ... 50 51 52 53 54 55 56 57 58 59 60 ... 141 142

Comments to this Manuals

No comments