Muratec M-1900 User Manual download pdf (Page 106)

All trademarks are property of their respective owners. Uni-Kit

has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.

All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.

Please be advised that some toner rell kits may be

compatible with multiple toner cartridges.

CLICK HERE TO GO THE INDEX

Magicolor 2400 Series

STEP 1

You need to nd the STATUS DISPLAY icon for your QMS 2400

printer. To locate this icon, go to START  PROGRAMS 

KONICA MINOLTA 2400 UTILITIES  and then select “STA-

TUS”.

STEP 2

In the menu bar on top, select “PRINTER” and then select

“MODE SETTING”.

STEP 3

Uncheck the “AUTO TONER REPLACE” and then save or click

OK if prompted

STEP 4

Now turn your printer off, and then turn it back on a few seconds

later.

Magicolor 2430 Series

STEP 1

On your Magicolor 2430 series printer, make sure the panel display says

“READY”. Then press the MENU/SELECT button.

STEP 2

By scrolling with the right arrow button, continue until you stop at selec-

tion “ENGINE”. Now press the MENU/SELECT button again.

STEP 3

Scroll again with the right arrow button until you get to “TONER EMP-

TY”. Press the MENU/SELECT button again.

STEP 4

Press the right arrow button until you get to “TONER IS EMPTY OR

OUT”

STEP 5

Press MENU/SELECT button once more, and then press the UP arrow

until you see “READY”.

The following reset procedure will enable the printer to continue printing even though the toner level will say “empty”.

INSTRUCTIONS ON HOW TO REPLACE THE CHIPS

Replacement chips are available for those customers who want to restore the “toner level monitoring” features that the chips have. If you have

bought the replacement chip, please follow these simple chip replacement instructions:

1) Remove the old chip by rst removing the screw in the top left hand corner of the diagram below

2) If your cartridge has an original chip with TWO holes in it (same as the photo below) and if the chip you have bought only has ONE hole, then

you need to follow step (3). If your cartridge does not look like the photo below, then move on to step (4)

3) --- you can skip this step if your cartridge does not look like the one in the photo below --- Using a at utility knife or blade, cut the plastic

protrusion that is behind the chip on the top right corner. This plastic protrusion sticks through the original QMS 2400 chip but has no purpose. If

the replacement chip you purchased does not have a hole for this protrusion to t into, the protrusion will push on the chip unless you shave away

at the protrusion by 1-2 mm. Then the new replacement chip can sit snuggly over the protrusion and not stick out.

4) Replace the new chip by replacing the screw and the new chip in the same orientation

Photo of a chip with TWO holes and a protrusion jutting through the right hole.

If the new chip you have only has ONE hole on the left, follow step (3) above.

KONICA MINOLTA QMS 2400 Series

Xerox 6120

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 141 142

Comments to this Manuals

No comments

Muratec M-1900 User Manual Page 106

Comments to this Manuals

Related products and manuals for Fax machines Muratec M-1900