Muratec M-1900 User Manual Page 124

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 123
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
117
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
A. Remove the 3 screws on the right
end cap.
B. Gently pry off plastic drum axle
bushing. Keep this
C. On the top edge of the end cap,
there is a plastic tab. Press in on the tab
and remove the right end cap.
D. Remove plug (circled in red) and
remove any remaining toner before
relling.
E. Replace the chip by cutting the
plastic rivets, drilling two holes, and
setting two self tapping screws in
place.
REQUIRED FOR A SUCCESSFUL REFILL:
 Toner
 1 funnel cap
General Relling Procedures:
Using the screw driver, remove the screws on the side of the cartridge so that the sealing
plug can be revealed (Illustration A,B, & C.). Once you have located the sealing plug, use
the at head screw driver to gently loosen the sealing plug(Illustration D.). With the needle
nose pliers, gently, but forcefully pull the plug completely off the cartridge. If the plug hap-
pens to bent or crack, you may use electrical tape or duct tape to securely seal the cracks or
bents once you have replaced the plug at the end of the rell process.
IMPORTANT: You must dispose of any original toner in the cartridge as much as pos-
sible before relling. Dispose of toner properly into a trash can.
Before opening the bottle of toner, turn it upside down and tap it on a table to loosen the
toner and allow it to ow freely. Remove the cap and pull the seal off the bottle. Attach
the funnel cap making to sure it is on tightly. Tilt the funnel cap toward the lling hole and
insert it into the hole. If the toner stops owing before the cartridge is full, simply remove
the toner, close the cap, turn the bottle upside down and tap it on a table. Once the cartridge
is full seal the hole with the plug.
Replace the chip by follwing the directions on illustration E. Once you have nished re-
placing the chip, gently shake the cartridge side to side to distribute the toner.
SAMSUNG 3050 / 2850 / 2851 / 4826
Page view 123
1 2 ... 119 120 121 122 123 124 125 126 127 128 129 ... 141 142

Comments to this Manuals

No comments