© All rights reserved, Easy Group, . Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
II
Thank you for purchasing a Uni-Kit toner rell kit. If you have any questions about the use of
these products, please check our FAQ’s below or email our technical support at support@uni-kit.
com. Uni-Kit is dedicated to providing high quality products at prices that allow our customers
to save signicantly compared to buying original cartridges. Relling your toner cartridge also
helps the environment as your empty toner cartridge can be revived instead of landing up in a
landll.
The relling procedure is simple in most cases – make a hole (or uncover a hole) in the cartridge,
rell it, and seal it. For specic instructions on your specic model please locate your model in
our instruction booklet. While relling a toner cartridge poses no signicant risk to your health,
we ask you to rell outside whenever possible and always use common sense when handling the
toner hole making tool or when pouring the toner.
Using the toner hole making tool:
This tool is an electrical appliance that is used to make a hole in the cartridge by rst heating
up to a desired temperature. Be careful when handling this tool so that you don’t burn yourself
or anything around you, the tool gets very HOT! You will need to wait for the tool to heat up
for about 3-5 minutes before using it to burn a hole in the desired location on the cartridge (see
specic cartridge instructions for location of hole). While waiting for the tool to heat up or cool
down, rest the tool on the tool stand as shown in this diagram above.
Pouring the toner:
To our knowledge, the average DIY reller’s exposure to fumes presents no signicant health
hazard in normal use. We recommend relling in a well ventilated room or outside to minimize
the exposure to fumes. For extra protection, wear a dust mask.
FAQ’s FOR THE UNI-KIT TONER REFILL KITS
1. Will your toner harm my printer or photocopier?
If you follow our simple instructions and inspect your work before reinstalling your cartridge,
there is no way the cartridge you rell can harm your machine.
2. Will the use of your toner void my warranty?
Nope! In fact, it is against the law (the Sherman and Clayton Anti-Trust Acts, to be specic) to
tie the purchase or use of a particular supply to the warranty.
GENERAL INSTRUCTIONS – PLEASE READ BEFORE REFILLING
3. Are there any hazards involved with the handling of toner?
HP describes toner as “Toner is a nontoxic substance composed of plastic, iron, and a small amount
of pigment.”
Much like the fumes released from gasoline in cars or from active or passive smoking or even
from inert dust and chemicals in the environment, the exposure to fumes from toner or from burn-
ing a hole in the cartridge (when necessary) could of course be hazardous. To our knowledge, the
average DIY reller’s exposure to fumes presents no signicant health hazard in normal use. We
recommend relling in a well ventilated room or outside to minimize the exposure to fumes. For
extra protection, wear a dust mask.
4. How many times can I rell my toner cartridge?
An average of three times (It varies depending on cartridge type). The range is from 1 or 2 times, to
5 or more times. Quality and page yield will decrease the more times a cartridge is relled. While
we have had reports from some users that they have been able to use our toner an even greater
number of times on a given empty, the simple (and obvious) rule of thumb is, continue to use our
toner until you are no longer satised with the print quality.
5. Why are the kits named after formulas instead of names of printers?
The “engine” in your laser printer is also manufactured to be used in dozens, even hundreds of
other printers.
Canon actually makes all of the Hewlett Packard laser printers and toner cartridges. Hewlett Pack-
ard does not make a single laser printer nor do they make a single toner cartridge.
6. If the relled cartridge using your toner won’t hurt the printer, what, if anything, can go
wrong?
Just like a new cartridge, if there is ever anything that goes wrong, it normally shows up on the
printed output. If you notice spots, dots, blank spots or voids showing up on the printed page (in
a pattern that repeats several times down the page), then the cartridge has reached the end of its
useful life and needs to be replaced. A razor sharp, pencil thin line appearing on the page also
indicates a cartridge has reached the end of the line.
7. Is your toner made by the same company that makes the brand-name cartridge toner?
There is no way to know for sure. Many laser printer manufacturers do not make their own toner.
We use toner formulas that match as closely as possible the properties of the original toner they
are replacing. Our toners are tested not only for excellent quality prints like the original, but also
for page yield so that you get about the same amount of printed pages as the original cartridge on
the rst rell.
Comments to this Manuals