Muratec M-1900 User Manual Page 24

  • Download
  • Add to my manuals
  • Print
  • Page
    / 142
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 23
© All rights reserved, Easy Group, LLC. Version 6.0
All trademarks are property of their respective owners. Uni-Kit
®
has no association with any of the manufacturers listed here such as Hp, Epson, Lexmark, Xerox, etc.
All logos and brand names shown here are used for identication purposes only. It is illegal to reproduce these instructions without written licensing consent from Easy Group LLC.
17
Please be advised that some toner rell kits may be
compatible with multiple toner cartridges.
CLICK HERE TO GO THE INDEX
DELL P1600
BEFORE YOU REFILL THIS CARTRIDGE, it is necessary to open the cartridge and replace the smartchip. Be sure to do this at a
workbench, outside, or anywhere where you can tolerate a spill. If you are careful there will be no spill.
1) Allow the cartridge to rest on a at surface with the top of the cartridge facing up, like the picture below.
2) Using a screwdriver, remove the 5 screws that are located on the TOP of the cartridge as shown
3) Slowly remove the top cover of the cartridge
4) You have now separated the cartridge into 2 parts (the cover, and the underlying part)
5) Locate the smartchip as shown in the image below, and replace it with a new replacement chip
6) Now replace the cover of the cartridge and replace all 5 screws, making sure the cover is securely attached
NOW YOU CAN REFILL THE CARTRIDGE USING THE BOTTLE OF TONER
1) Identify the lling hole on the side of the cartridge as shown in the picture. There may be a sticker over the
lling cap that says “DO NOT REMOVE”. It is OK to remove this sticker. The plastic sealing cap can be eas-
ily removed by prying it out with a at screwdriver, but be careful not to damage this plastic cap as you need to
place it back after you rell
2) Now you can ll the cartridge with toner. Before opening the bottle of toner, turn it upside down and tap it on
a table to loosen the toner and allow it to ow freely. Remove the cap and pull the seal off the bottle. Attach the
funnel cap making to sure it is on tightly. Tilt the funnel cap toward the lling hole and insert it into the hole. If
the toner stops owing before the cartridge is full, simply remove the toner, close the cap, turn the bottle upside
down and tap it on a table. Once the cartridge is full seal the hole with the original plug.
1) Top of the cartridge facing up
2) Remove the 5 screws
5) Replace the smartchip with a new chip
3) Remove the toner cap
4) By so doing, you sepa-
rate the cartridge into 2
parts. The smartchip is in
the bottom part, identied
by the arrow
Page view 23
1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 141 142

Comments to this Manuals

No comments